Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Kohler Fence Installation: The Fort Lauderdale Owner’s Guide
A Kohler fence installation in Fort Lauderdale typically runs $3,500 to $9,000 installed, depending on fence height, linear footage, and whether we’re replacing rusted posts or working around existing hardscape. We stock Kohler-compatible fence components and hardware, and in most cases we can have your fence secured the same week you call. Most homeowners discover the problem the same way: a gate that drags on the pavers after a storm, a post that leans after one good rain, or hardware that’s corroded to the point where the latch won’t catch. If you’re standing in the backyard and the fence wobbles when you push it, that’s the moment to call before the whole panel comes down on a windy afternoon.
We’re an independent service provider in Fort Lauderdale, not affiliated with Kohler, but we’ve worked on enough Kohler fence systems across the city to know exactly which parts fail and which ones are worth salvaging.
Which Kohler Models This Applies To
The reality with Kohler fencing is that most of the residential lines share the same post profile and rail channel system, which is good news if you’re trying to match an existing run. The common thread is a 2-inch square aluminum post with internal rail brackets, and Kohler’s fence panels are sized in 6-foot and 8-foot sections. Where things get tricky is with the gate hardware. Kohler changed gate hinge suppliers a few times over the years, and the older self-closing hinges don’t accept the current replacement hinge bodies without drilling new holes. If you’ve got a gate that’s five to seven years old, expect a small modification, not a direct swap. For the panels themselves, genuine Kohler replacement sections are the cleanest match, but quality aftermarket aluminum panels in the same gauge and powder coat color hold up just as well in Fort Lauderdale’s salt air, and they cost about 20 percent less. We stock both and we’ll show you the difference before you spend a dollar.
Styles & brands we work with
Signs Your Kohler Fence Installation Is Failing
- Leaning posts near sprinkler heads. Fort Lauderdale’s sandy soil doesn’t hold a concrete footer like clay does. When a post starts leaning, the footer was usually poured too shallow or the sprinkler has been saturating the same spot for years. We dig it out, reset it deeper, and pack it right.
- Gate that scrapes or won’t latch. This is almost always sag at the hinge side. The post is fine; the hinge has worn or the gate frame has twisted. Sometimes a shim fixes it, sometimes the hinge needs replacement. Both are cheaper than a new gate.
- Powder coat bubbling along the bottom rail. Salt spray from the ocean works its way into micro-scratches and lifts the coating. It starts cosmetic, but once bare aluminum is exposed, corrosion spreads fast. A touch-up kit won’t stop it; the rail needs sanding, priming, and recoating.
- Loose pickets that rattle when you close the gate. The picket crimps loosen over time from wind and gate vibration. Tightening only helps if the crimp channel isn’t cracked. When it’s cracked, that picket needs replacement.
- Gate closer slamming instead of easing shut. Kohler’s hydraulic closers lose their seal after a few South Florida summers. The cylinder stops holding pressure and the gate slams hard enough to shake the whole panel. That’s a $60 to $90 part and a 20-minute fix, and we keep them on the truck.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Fort Lauderdale, a full Kohler fence installation runs $3,500 to $9,000, and the spread comes down to three things: linear footage, gate count, and whether we’re removing an old fence or setting posts fresh. A short run of forty feet with one gate sits near the low end. A full perimeter with two walk gates and a driveway gate lands at the high end. Our written price includes the fence material, posts, concrete for each footer, all hardware, the old fence haul-away, and the labor to install and level every panel. You’ll get the number in writing before we order anything, and the work is covered by our 365-Day Done Right Promise: if something isn’t right within a year of completion, we come back and make it right at no cost. No fine-print exceptions, no dispute process. We tell you what we found, what it takes to fix it, and what it will cost – before we touch a thing.
DIY or Call Us?
You can safely check the gate hinges, tighten a loose latch plate, and clear vegetation from around the post bases. What you shouldn’t do is reset a leaning post yourself. Pulling a post out of the ground sounds simple, but getting it plumb and square in Fort Lauderdale’s sandy soil takes experience, and a post that’s off by half a degree looks worse every year. The other thing we see a lot: homeowners who replace a panel with a big-box section that’s a slightly different height or color, then call us to fix the mismatch. Matching Kohler’s existing powder coat and rail profile takes a measured eye and the right supplier. If you’re not sure whether it’s a quick fix or a full replacement, call (754) 354-3720 and describe what you’re seeing. We’ll tell you straight up what it likely is and what it costs to address, before anyone schedules a visit.
FAQs
With quality posts set in proper concrete footers and coated hardware, a Kohler fence in Fort Lauderdale lasts 12 to 18 years before panels start showing serious wear. The failure point is usually the bottom rail and gate hinges, not the pickets. Homes closer to the Intracoastal or the ocean are on the shorter end of that range because of salt air. If your fence is over a decade old and the bottom rails are bubbling, it’s time to budget for replacement rather than patching it every few months. Call (754) 354-3720 for an exact assessment and a written price.
Yes, in most cases a leaning post can be re-set in a new concrete footer without replacing the post itself. The post gets pulled, the old footer gets broken out, and a new one gets poured deeper and wider. The exception is when the post has rotted or corroded at ground level, in which case you’re better off replacing that post while the hole is open. We’ll tell you which one you have when we look.
A standard residential fence installation in Fort Lauderdale takes one to two days on site, plus a day for the concrete to cure before gates are hung. If we’re removing an old fence and hauling it away, add a half day. Weather can stretch the schedule, since pouring concrete in a Florida downpour doesn’t work. We’ll give you the timeline in writing with the price, and we stick to it.
We stock the common failure points: gate hinges, hydraulic closers, latch assemblies, pickets, and bottom rail stock, both genuine Kohler and quality aftermarket equivalents. Oddball items like a custom gate frame or a specific powder coat color for a large panel usually take three to five business days to source. We handle all of that for you, and you’ll see the part cost listed on the written estimate before we order. No surprises, no markup games.
If your Kohler fence is sagging, leaning, or just looks tired after years of Fort Lauderdale weather, call (754) 354-3720 and ask for Isaac. We’ll walk you through what’s likely going on, give you an honest price range over the phone, and set up a free estimate if it makes sense. No pressure, no obligation, just a straight answer from a crew that does this work every week.
Written by Isaac Pruett, Owner, Mason Remodeling Co Fort Lauderdale at Mason Remodeling Co Fort Lauderdale, serving Fort Lauderdale and nearby areas.
